Rear Brake Rotor – 300x12mm

Premium replacement rear solid brake rotor designed for direct fitment on compatible Volkswagen and Audi vehicles using a 300 mm disc diameter and 5-lug 5x112mm hub pattern. The 12mm nominal thickness and high-quality cast iron construction help ensure consistent braking performance and long service life.

The rotor features a UV-coated corrosion-resistant finish that protects the outer edge and hub area, helping maintain structural integrity and appearance in harsh road conditions. Over time, rotors may develop wear, warpage, glazing or corrosion, leading to brake vibration, noise or reduced efficiency. Replacing a worn or damaged rotor restores optimal braking behavior and driver confidence.

• Fitment: Rear axle, solid disc design
• Dimensions: 300 mm diameter x 12 mm nominal thickness
• Center bore: 65 mm; Bolt pattern: 5 holes (5x112mm)
• Construction: Premium cast iron; Corrosion protection: UV-coated finish

Note: This rotor is designed for vehicles configured with a solid rear brake disc. It is not suitable for models that utilize vented, drilled or two-piece rear rotors. Always check vehicle VIN and rear axle brake system configuration before ordering.

Installation Notes:

• Clean hub surface thoroughly to ensure proper rotor seating
• Check rotor run-out to avoid vibration under braking
• Tighten wheel bolts to manufacturer-specified torque after installation
• Perform proper bed-in procedure when replacing rotor and pads together

Recommended when replacing rear rotors that show signs of wear, scoring, warpage, or corrosion—restoring safe, quiet and effective braking performance.